Добірка наукової літератури з теми "Weak local residuals"
Оформте джерело за APA, MLA, Chicago, Harvard та іншими стилями
Ознайомтеся зі списками актуальних статей, книг, дисертацій, тез та інших наукових джерел на тему "Weak local residuals".
Біля кожної праці в переліку літератури доступна кнопка «Додати до бібліографії». Скористайтеся нею – і ми автоматично оформимо бібліографічне посилання на обрану працю в потрібному вам стилі цитування: APA, MLA, «Гарвард», «Чикаго», «Ванкувер» тощо.
Також ви можете завантажити повний текст наукової публікації у форматі «.pdf» та прочитати онлайн анотацію до роботи, якщо відповідні параметри наявні в метаданих.
Статті в журналах з теми "Weak local residuals"
Mungkasi, Sudi, and Stephen Gwyn Roberts. "Weak Local Residuals as Smoothness Indicators in Adaptive Mesh Methods for Shallow Water Flows." Symmetry 12, no. 3 (March 1, 2020): 345. http://dx.doi.org/10.3390/sym12030345.
Повний текст джерелаMungkasi, Sudi, Zhenquan Li, and Stephen Gwyn Roberts. "Weak local residuals as smoothness indicators for the shallow water equations." Applied Mathematics Letters 30 (April 2014): 51–55. http://dx.doi.org/10.1016/j.aml.2013.12.007.
Повний текст джерелаRoberts, Stephen Gwyn, and Sudi Mungkasi. "Well-balanced computations of weak local residuals for the shallow water equations." ANZIAM Journal 55 (December 9, 2015): 128. http://dx.doi.org/10.21914/anziamj.v56i0.9369.
Повний текст джерелаJia, Zhuo, Sixin Liu, Ling Zhang, Bin Hu, and Jianmin Zhang. "Weak Signal Extraction from Lunar Penetrating Radar Channel 1 Data Based on Local Correlation." Electronics 8, no. 5 (May 23, 2019): 573. http://dx.doi.org/10.3390/electronics8050573.
Повний текст джерелаAlcantara, C. A., J. D. Escoto, A. C. Blanco, A. B. Baloloy, J. A. Santos, and R. R. Sta. Ana. "GEOSPATIAL ASSESSMENT AND MODELING OF URBAN HEAT ISLANDS IN QUEZON CITY, PHILIPPINES USING OLS AND GEOGRAPHICALLY WEIGHTED REGRESSION." ISPRS - International Archives of the Photogrammetry, Remote Sensing and Spatial Information Sciences XLII-4/W16 (October 1, 2019): 85–92. http://dx.doi.org/10.5194/isprs-archives-xlii-4-w16-85-2019.
Повний текст джерелаMircheva, Biliana, Milen Tsekov, Ulrich Meyer, and Guergana Guerova. "Analysis of the 2014 Wet Extreme in Bulgaria: Anomalies of Temperature, Precipitation and Terrestrial Water Storage." Hydrology 7, no. 3 (September 9, 2020): 66. http://dx.doi.org/10.3390/hydrology7030066.
Повний текст джерелаRen, Zhiming, and Yang Liu. "A hierarchical elastic full-waveform inversion scheme based on wavefield separation and the multistep-length approach." GEOPHYSICS 81, no. 3 (May 2016): R99—R123. http://dx.doi.org/10.1190/geo2015-0431.1.
Повний текст джерелаMusialkowska, Ida, Agata Kliber, Katarzyna Świerczyńska, and Paweł Marszałek. "Looking for a safe-haven in a crisis-driven Venezuela." Transforming Government: People, Process and Policy 14, no. 3 (April 20, 2020): 475–94. http://dx.doi.org/10.1108/tg-01-2020-0009.
Повний текст джерелаBaryshnikov, Sergei O., Alla B. Krasiuk, and Valentin B. Chistov. "THE INFLUENCE OF LOCAL RESIDUAL DEFORMATIONS ON THE SHIPS HULLS RELIABILITY." Vestnik Gosudarstvennogo universiteta morskogo i rechnogo flota imeni admirala S. O. Makarova 14, no. 3 (September 2, 2022): 403–16. http://dx.doi.org/10.21821/2309-5180-2022-14-3-403-416.
Повний текст джерелаLam, William, Kalev Kask, Javier Larrosa, and Rina Dechter. "Residual-Guided Look-Ahead in AND/OR Search for Graphical Models." Journal of Artificial Intelligence Research 60 (October 20, 2017): 287–346. http://dx.doi.org/10.1613/jair.5475.
Повний текст джерелаДисертації з теми "Weak local residuals"
Ferré, Romain. "Etude expérimentale et modélisation de la durabilité d'un contact représentatif de l'interface aube / disque de soufflante grenaillé soumis à des chargements de fretting / fatigue / usure." Thesis, Ecully, Ecole centrale de Lyon, 2013. http://www.theses.fr/2013ECDL0012.
Повний текст джерелаThis work aims at studying the crack initiation risk of a blade/disk contact under fretting/fatigue loading. The fan stage of a civil engine is studied and the material used is a titanium alloy: Ti-6Al-4V. This complex issue concerns small contacts which are subjected to high contact pressures and micro-displacements. Thus, a complex multiaxial loading occurs on the structure. Fretting, static stressed fretting and fretting fatigue testing are performed in order to quantify the crack nucleation thresholds. In addition, several geometries which present different stress gradient values are used. The experimental results show a stress gradient effect on the crack initiation. Thus, using a wide range of stress gradient, it has been confirmed that stress gradient delays crack nucleation. A multiaxial fatigue criterion is used to determine the equivalent stress field under the contact. Then, a non-local approach, identified thanks to one fretting experimental condition, is employed in order to consider the stress gradient effect. This approach provides the prediction of the whole experimental results. In this way, a predictive method of the initiation fatigue life has been introduced. This numerical approach takes into account the multiaxial loading, the stress gradient effect, the plastic-elastic behavior of the interface and the fatigue strength limits of the material. The blade/disk contacts of the engine are shot-peened. During the flight, interfaces are subjected to low displacement amplitudes leading to crack initiation. On the other hand, during landing and take-off, contacts are submitted to high displacement amplitudes leading to the interface wear. As a consequence, competition between wear kinetic and nucleation one is studied and “bell curves” are plotted (i.e. fatigue life time versus displacement amplitude).Moreover, the effect of the shot-peening residual stresses on fatigue life time is observed. In case of un-treated material, a beneficial impact on the fatigue life time is observed due to wear process. Compressive residual stresses of shot-peening increase the fatigue life when fretting/fatigue on partial slip regime occurs. Nevertheless, a decrease of the fatigue life time is observed when wear process is activated by the gross slip condition. Finally, the complex loading of the engine blade/disk contact has been reproduced in the laboratory. To achieve this, a new testing, using an experimental machine composed of three hydraulic actuators is developed. Thus, the global life time of the representative interface of the fan stage is studied. Oligocyclic (low frequency) and polycyclic (high frequency) solicitations interact themselves and lead, firstly, to a rearrangement of the residual stresses, and secondly, to an increase of the wear kinetics. This research work highlights the interest to consider the polycyclic loadings to design the blade/disk structure. These solicitations reproduce the “cracking” fatigue phenomenon, the cumulative damages and the wear kinetics of the interface
Mungkasi, Sudi. "A study of well-balanced finite volume methods and refinement indicators for the shallow water equations." Phd thesis, 2012. http://hdl.handle.net/1885/10301.
Повний текст джерелаЧастини книг з теми "Weak local residuals"
Miller, D. Gary. "The nominal system." In The Oxford Gothic Grammar, 58–101. Oxford University Press, 2019. http://dx.doi.org/10.1093/oso/9780198813590.003.0003.
Повний текст джерелаKompanets, Eduard, and Viktoria Lavrynenko. "ECOSYSTEM CONNECTIONS AND FISH HEALTH." In Priority areas for development of scientific research: domestic and foreign experience. Publishing House “Baltija Publishing”, 2021. http://dx.doi.org/10.30525/978-9934-26-049-0-40.
Повний текст джерелаТези доповідей конференцій з теми "Weak local residuals"
Moliere, Michel. "Benefiting From the Wide Fuel Capability of Gas Turbines: A Review of Application Opportunities." In ASME Turbo Expo 2002: Power for Land, Sea, and Air. ASMEDC, 2002. http://dx.doi.org/10.1115/gt2002-30017.
Повний текст джерелаIrmisch, Stefan. "Adaptive Finite-Volume Solution of the Two-Dimensional Euler Equations on Unstructured Meshes." In ASME 1994 International Gas Turbine and Aeroengine Congress and Exposition. American Society of Mechanical Engineers, 1994. http://dx.doi.org/10.1115/94-gt-087.
Повний текст джерелаWilk, Andrzej B., Henryk M. Madej, and Bogusław E. Łazarz. "Vibration Processing Techniques for Fault Detection in Gearboxes." In ASME 2003 International Design Engineering Technical Conferences and Computers and Information in Engineering Conference. ASMEDC, 2003. http://dx.doi.org/10.1115/detc2003/ptg-48084.
Повний текст джерелаMurata, Naokazu, Naoki Saito, Kinji Tamakawa, Ken Suzuki, and Hideo Miura. "Effect of Crystallographic Quality of Grain Boundaries on Both Mechanical and Electrical Properties of Electroplated Copper Thin Film Interconnections." In ASME 2011 Pacific Rim Technical Conference and Exhibition on Packaging and Integration of Electronic and Photonic Systems. ASMEDC, 2011. http://dx.doi.org/10.1115/ipack2011-52048.
Повний текст джерелаVerhaeghe, R., G. Wilms, P. Mombaerts, J. Vermylen, A. Baert, and M. Verstraete. "FEMORO-POPLITEAL ARTERY THROMBOLYSIS WITH INTRA-ARTERIAL INFUSION OF RECOMBINANT TISSUE-TYPE PLASMINOGEN ACTIVATOR (rt-PA)." In XIth International Congress on Thrombosis and Haemostasis. Schattauer GmbH, 1987. http://dx.doi.org/10.1055/s-0038-1643892.
Повний текст джерелаMurata, Naokazu, Naoki Saito, Kinji Tamakawa, Ken Suzuki, and Hideo Miura. "Micro Texture Dependence of Both the Mechanical and Electrical Properties of Electroplated Copper Thin Films Used for Interconnection." In ASME 2010 International Mechanical Engineering Congress and Exposition. ASMEDC, 2010. http://dx.doi.org/10.1115/imece2010-37279.
Повний текст джерелаMusil, J., V. Dolhof, and E. Dvorácek. "Repair of Water Turbine Blades by Wire Electric Arc Spraying." In ITSC 1996, edited by C. C. Berndt. ASM International, 1996. http://dx.doi.org/10.31399/asm.cp.itsc1996p0911.
Повний текст джерелаNaboulsi, Sam. "A Crystallographic Approach to Life Prediction Analysis of a Turbine Engine Blade to Disk Attachment." In ASME 2014 International Mechanical Engineering Congress and Exposition. American Society of Mechanical Engineers, 2014. http://dx.doi.org/10.1115/imece2014-40208.
Повний текст джерелаVilarinho, Cândida, José Teixeira, Jorge Araújo, and Joana Carvalho. "Effect of Time and Acid Concentration on Metal Extraction From Galvanic Sludges." In ASME 2017 International Mechanical Engineering Congress and Exposition. American Society of Mechanical Engineers, 2017. http://dx.doi.org/10.1115/imece2017-71370.
Повний текст джерелаLavagnoli, S., C. De Maesschalck, and V. Andreoli. "Design Considerations for Tip Clearance Control and Measurement on a Turbine Rainbow Rotor With Multiple Blade Tip Geometries." In ASME Turbo Expo 2016: Turbomachinery Technical Conference and Exposition. American Society of Mechanical Engineers, 2016. http://dx.doi.org/10.1115/gt2016-56544.
Повний текст джерела