Книги з теми "Heat of the cooling system"

Herro, Harvey M. The Nalco guide to cooling water system failure analysis. New York: McGraw-Hill, 1993.

Ontario. Ministry of Agriculture and Food. Heat Recovery From Milk Cooling Systems. S.l: s.n, 1988.

D, Port Robert, and Nalco Chemical Company, eds. The Nalco guide to cooling water system failure analysis: Nalco Chemical Company. New York: McGraw-Hill, 1993.

Abdul-Aziz, Ali. Effects of cooling system parameters on heat transfer in PAFC stack. [Washington, DC: National Aeronautics and Space Administration, 1985.

C, Howard Brian, ed. Geothermal HVAC: Green heating and cooling. New York: McGraw-Hill, 2011.

An introduction to thermogeology: Ground source heating and cooling. 2nd ed. Hoboken, NJ: John Wiley & Sons, Ltd., 2012.

An introduction to thermogeology: Ground source heating and cooling. Oxford: Blackwell Pub., 2008.

Lomax, Curtis. A direct-interface, fusible heat sink for astronaut cooling. Moffett Field, Calif: National Aeronautics and Space Administration, Ames Research Center, 1990.

Stojanowski, John. Residential geothermal systems: Heating and cooling using the ground below. 2nd ed. Staten Island, NY: Pangea Publications, 2011.

Kveton, O. K. ITER cooling system: Analysis of heat transfer media, operation and safety of cooling loop and blanket during conditioning and baking. Toronto: Ontario Hydro, 1990.

Clements, Joseph A. Heat transfer performance of a roof-spray cooling system employing the transfer function method. Springfield, Va: Available from the National Technical Information Service, 1993.

Nee, Michael J. Heat exchanger engineering techniques: Process, air conditioning, and electronic systems. New York: ASME Press, 2003.

Lloyd, Donal Blaise. The smart guide to geothermal: How to harvest Earth's free energy for heating & cooling. Masonville, CO: PixyJack Press, 2011.

Nee, Michael J. Heat exchanger engineering techniques: Process, air conditioning, and electronic systems : a treatise on heat exchanger installations that did not meet performance. New York: ASME Press, 2003.

(Firm), VBB Allen. Feasibility of energy recovery for heat pump-assisted district heating & cooling from the Metro Renton wastewater treatment plant and effluent transfer system: Phase 2 report. Salem, Or: VBB Allen, 1986.

Johnson, Richard P. A preliminary design and analysis of an advanced heat-rejection system for an extreme altitude advanced variable cycle diesel engine installed in high-altitude advanced research plaftorm. Edwards, Calif: National Aeronautics and Space Administration, Dryden Flight Research Facility, 1992.

Ward, L. W. Consequences of the loss of the residual heat removal systems in pressurized water reactors. Washington, DC: Division of Systems Technology, Office of Nuclear Reactor Regulation, U.S. Nuclear Regulatory Commission, 1992.

Ward, L. W. Consequences of the loss of the residual heat removal systems in pressurized water reactors. Washington, DC: Division of Systems Technology, Office of Nuclear Reactor Regulation, U.S. Nuclear Regulatory Commission, 1992.

Xuejun, Luo, and Xu Mi, eds. Kuai dui zhu re chuan shu xi tong ji fu zhu xi tong. Beijing Shi: Zhongguo yuan zi neng chu ban she, 2011.

Yi, Chʻun-u. Yongnyang kabyŏnhyŏng chiyŏrwŏn tajung konggan naengnanbang sisŭtʻem =: The development of capacity variable type geo-thermal source multi space cooling & heating system. [Seoul]: Chisik Kyŏngjebu, 2008.

Yi, Chʻun-u. Yongnyang kabyŏnhyŏng chiyŏrwŏn tajung konggan naengnanbang sisŭtʻem =: The development of capacity variable type geo-thermal source multi space cooling & heating system. [Seoul]: Chisik Kyŏngjebu, 2008.

Yi, Chʻun-u. Yongnyang kabyŏnhyŏng chiyŏrwŏn tajung konggan naengnanbang sisŭtʻem =: The development of capacity variable type geo-thermal source multi space cooling & heating system. [Seoul]: Chisik Kyŏngjebu, 2008.

Rodriguez, Ferdinand. Principles of polymer systems. 3rd ed. New York: Hemisphere Pub. Corp., 1989.

Rodriguez, Ferdinand. Principles of polymer systems. 4th ed. Washington, DC: Taylor & Francis, 1996.

Rodriguez, Ferdinand. Principles of polymer systems. 4th ed. Washington, DC: Taylor & Francis, 1996.

A, Wirtz R., Lehmann G. L, and American Society of Mechanical Engineers. Heat Transfer Division., eds. Thermal modeling and design of electronic systems and devices: Presented at the Winter Annual Meeting of the American Society of Mechanical Engineers, Dallas, Texas, November 25-30, 1990. New York, N.Y: American Society of Mechanical Engineers, 1990.

Cramond, Wallis R. Shutdown decay heat removal analysis of a combustion engineering 2-loop pressurized water reactor: Case study. Washington, DC: Division of Reactor and Plant Systems, Office of Nuclear Regulatory Research, U.S. Nuclear Regulatory Commission, 1987.

Mihaylov, Vyacheslav, Elena Sotnikova, and Nina Kalpina. Eco-friendly air protection systems for motor transport facilities. ru: INFRA-M Academic Publishing LLC., 2022. http://dx.doi.org/10.12737/1093106.

Cavanagh, James Edward. Development of a high resolution, high heat transfer coolant system for the process control of cold strip rolling mills. Poole: Dorset Institute of Higher Education and Davy McKee (Poole) Ltd, 1985.

Lipták, Béla G. Optimization of unit operations: Boilers, chemical reactors, chillers, clean rooms, compressors, condensers, cooling towers, fans, fired heaters, heat exchangers, HVAC systems, pumping stations, reboilers, vaporizers. Radnor, Pa: Chilton Book Co., 1987.

Rigby, David L. Prediction of heat and mass transfer in a rotating ribbed coolant passage with a 180 degree turn. [Cleveland, Ohio]: National Aeronautics and Space Administration, Lewis Research Center, 1999.

Bejan, Adrian, and Giuseppe Grazzini, eds. Shape and Thermodynamics. Florence: Firenze University Press, 2008. http://dx.doi.org/10.36253/978-88-8453-836-9.

Dinçer, İbrahim. Heat transfer in food cooling applications. Washington, D.C: Taylor & Francis, 1997.

Silverstein, Calvin C. Heat pipe cooling for scramjet engines. [Washington, DC]: National Aeronautics and Space Administration, Scientific and Technical Information Branch, 1986.

Automotive cooling system basics. Iola, WI: Krause Publications, 1999.

Sandīpa, Datta, and Ekkad Srinath 1958-, eds. Gas turbine heat transfer and cooling technology. 2nd ed. Boca Raton, FL: Taylor & Francis, 2012.

1953-, Dutta Sandip, and Ekkad Srinath 1958-, eds. Gas turbine heat transfer and cooling technology. New York: Taylor & Francis, 2000.

Lun, Y. H. Venus, and S. L. Dennis Tung. Heat Pumps for Sustainable Heating and Cooling. Cham: Springer International Publishing, 2020. http://dx.doi.org/10.1007/978-3-030-31387-6.

Marto, P. J. Heat pipe cooling of large electric motors. Monterey, Calif: Naval Postgraduate School, 1988.

North Atlantic Treaty Organization. Advisory Group for Aerospace Research and Development. Heat Transfer and Cooling in Gas Turbines. S.l: s.n, 1985.

Frederick, Nicholas D. Plain and finned tube scaling in a deluged dry cooling system. 1985.

Stevens, Owen L. Characterization of the Advanced Plant Experiment (APEX) passive residual heat removal system heat exchanger. 1996.

S, Kakaç, Yüncü H, Hijikata H, and NATO Advanced Study Institute on Cooling of Electronic Systems (1993 : Çeşme, Turkey), eds. Cooling of electronic systems. Dordrecht: Kluwer Academic, 1994.

Engineers, Society of Automotive. Vehicle Heat Exchanger and Transfer Design. SAE International, 1996.

Engineers, Society of Automotive, and SAE International Congress & Exposition (1996 : Detroit, Mich.), eds. Vehicle heat exchanger and transfer design. Warrendale, PA: Society of Automotive Engineers, 1996.

Sarbu, Ioan, and Calin Sebarchievici. Solar Heating and Cooling Systems: Fundamentals, Experiments and Applications. Elsevier Science & Technology Books, 2016.

Ogrenci-Memik. Heat Management in Integrated Circuits: On-chip and system-level monitoring and cooling. Institution of Engineering and Technology, 2015. http://dx.doi.org/10.1049/pbcs028e.

Cooling the cities =: Rafraîchir les villes : energy efficient cooling systems & techniques for urban buildings. Paris: Presses de l'École des mines, 2004.

W, Webbon B., and Ames Research Center, eds. A direct-interface, fusible heat sink for astronaut cooling. Moffett Field, Calif: National Aeronautics and Space Administration, Ames Research Center, 1990.

A direct-interface, fusible heat sink for astronaut cooling. Moffett Field, Calif: National Aeronautics and Space Administration, Ames Research Center, 1990.