Дисертації з теми "Aspen Plus modeling"
Оформте джерело за APA, MLA, Chicago, Harvard та іншими стилями
Ознайомтеся з топ-23 дисертацій для дослідження на тему "Aspen Plus modeling".
Біля кожної праці в переліку літератури доступна кнопка «Додати до бібліографії». Скористайтеся нею – і ми автоматично оформимо бібліографічне посилання на обрану працю в потрібному вам стилі цитування: APA, MLA, «Гарвард», «Чикаго», «Ванкувер» тощо.
Також ви можете завантажити повний текст наукової публікації у форматі «.pdf» та прочитати онлайн анотацію до роботи, якщо відповідні параметри наявні в метаданих.
Переглядайте дисертації для різних дисциплін та оформлюйте правильно вашу бібліографію.
Salih, Saif Yoseif. "THE MODELING OF PETROLEUM COKE GASIFICATION USING ASPEN PLUS SOFTWARE." OpenSIUC, 2015. https://opensiuc.lib.siu.edu/theses/1777.
Повний текст джерелаAbu, Bakar Nurul Atiqah. "Modeling, optimizing and control analysis of a debutanizer column using Aspen Plus and Aspen Dynamic." Thesis, Abu Bakar, Nurul Atiqah (2017) Modeling, optimizing and control analysis of a debutanizer column using Aspen Plus and Aspen Dynamic. Honours thesis, Murdoch University, 2017. https://researchrepository.murdoch.edu.au/id/eprint/41926/.
Повний текст джерелаSmestad, Haley Hayden. "Modeling of an Ethanol - Water- LiBr Ternary System for the Simulation of Bioethanol Purification using Pass-Through Distillation." Digital WPI, 2016. https://digitalcommons.wpi.edu/etd-theses/452.
Повний текст джерелаAfanga, Khalid. "Modélisation systémique des filières sidérurgiques en vue de leur optimisation énergétique et environnementale." Thesis, Université de Lorraine, 2014. http://www.theses.fr/2014LORR0268/document.
Повний текст джерелаThis research study deals with mathematical modeling of the main steelmaking processes following a systems approach. The objective was to build a modeling tool of the whole steelmaking route devoted to its energetic and environmental optimization. We developed physical-chemical models for the blast furnace, the coke oven, the sintering plant and the basic oxygen furnace. These models were then linked together in a single flow sheet using the ASPEN Plus software. First, we focused on the top gas recycling blast furnace, a novel variant of the blast furnace in which the top gas is recycled and re-injected into the tuyeres after CO2 removal and capture. We tested both a reinjection at one level (tuyeres only) and at two levels (tuyeres and shaft). The results were successfully compared with experimental data from a pilot reactor and demonstrate that recycling can lower the blast furnace CO2 emissions by more than 20%. Recycling at two levels does not seem more efficient than at a single level. Second, we simulated the operation of an entire integrated steelmaking plant. Different configurations were tested, using a conventional blast furnace or a top gas recycling blast furnace, considering a possible recycling of the converter slag to the sintering plant, and studying the influence of Si content in the hot metal on the entire steelmaking plant operation. We show that it is possible to reduce the cost of producing steel by substituting and recycling various by-products
Hedström, Sofia. "Thermal energy recovery of low grade waste heat in hydrogenation process." Thesis, Karlstads universitet, Fakulteten för hälsa, natur- och teknikvetenskap (from 2013), 2014. http://urn.kb.se/resolve?urn=urn:nbn:se:kau:diva-32335.
Повний текст джерелаFrançois, Jessica. "Modélisation et évaluation environnementale des filières de cogénération par combustion et gazéification du bois." Thesis, Université de Lorraine, 2014. http://www.theses.fr/2014LORR0071/document.
Повний текст джерелаBiomass is one of the most promising renewable energy source in Europe. Its use as a substitute to fossil energy is expected to mitigate climate change. However, potential drawbacks are also feared with large scale development. In order to assess the environmental impacts of the biomass-to-energy chain, we firstly developed a model of the bioenergy system, from the forest to the energy production. We focused on two biomass power plants for combined heat and power (CHP) production: one is based on the conventional direct combustion process while the other is based on the more advanced gasification process. Gasification offers higher electrical efficiency, but its development is still facing technical difficulties. In case of the gasification process, we defined the best operating conditions regarding energetic and exergetic efficiencies, as well as the syngas quality requirements. Secondly, we calculated the carbon and mineral flows taken from the forest through energy wood harvesting, along with the forested area required to feed the CHP plant. The other resources and emissions related to the plant operation were also predicted. We observed that more extensive forestry practices led to an increase in the mineral exports. Finally, we evaluated the environmental performance of the two biomass CHP plants using life cycle assessment (LCA). Within French energy context, we found that both CHP technologies had very similar impacts with a slight advantage toward the combustion process. It appears of particular benefit to replace current fossil energy systems with biomass CHP plants to reduce climate change
Higgins, Stuart James. "Design and Optimization of Post-Combustion CO2 Capture." Diss., Virginia Tech, 2016. http://hdl.handle.net/10919/80003.
Повний текст джерелаPh. D.
Ramirez, Jerome Luigi A. "Modelling a commercial-scale bagasse liquefaction plant using ASPEN Plus." Thesis, Queensland University of Technology, 2018. https://eprints.qut.edu.au/120019/1/Jerome_Ramirez_Thesis.pdf.
Повний текст джерелаNguyen, Hoa Huu. "Modelling of food waste digestion using ADM1 integrated with Aspen Plus." Thesis, University of Southampton, 2014. https://eprints.soton.ac.uk/375082/.
Повний текст джерелаOlofsson, Fanny, and Henrik Halvarsson. "SMALL SCALE ENERGY CONVERSION OF PLASTIC WASTE : Identification of gasification process parameters through modelling in Aspen Plus." Thesis, Mälardalens högskola, Akademin för ekonomi, samhälle och teknik, 2020. http://urn.kb.se/resolve?urn=urn:nbn:se:mdh:diva-49162.
Повний текст джерелаJurado, Pontes Nelia. "Experimental and modelling studies of coal/biomass oxy-fuel combustion in a pilot-scale PF combustor." Thesis, Cranfield University, 2014. http://dspace.lib.cranfield.ac.uk/handle/1826/9310.
Повний текст джерелаRaja, Kintali Vivek. "Optimization of Biodiesel Production using Aspen Plus." Thesis, 2015. http://ethesis.nitrkl.ac.in/6786/1/Optimization_Raja_2015.pdf.
Повний текст джерелаMahapatra, N. "Design and Simulation of Cumene Plant using Aspen Plus." Thesis, 2010. http://ethesis.nitrkl.ac.in/1746/1/nirlipt_ethesis.pdf.
Повний текст джерелаBala, Pritam Kumar. "Steady State Simulation of Extractive Distillation System Using Aspen Plus." Thesis, 2015. http://ethesis.nitrkl.ac.in/7115/1/Steady_Bala_2015.pdf.
Повний текст джерелаChoudhary, Sanjana Anand. "Simulation Analysis of A Propane Recovery Plant from Using ASPEN PLUS." Thesis, 2015. http://ethesis.nitrkl.ac.in/7040/1/Simulation_Choudhary_2015.pdf.
Повний текст джерелаRaosaheb, Parkhe Shashank. "Steady State Simulation of an Azeotropic Distillation System Using Aspen Plus." Thesis, 2015. http://ethesis.nitrkl.ac.in/7113/1/Steady_Raosaheb_2015.pdf.
Повний текст джерелаKumar, S. "Modelling and Simulation of Ethyl Acetate Reactive Distillation Column using ASPEN PLUS." Thesis, 2010. http://ethesis.nitrkl.ac.in/1944/1/3-joined.pdf.
Повний текст джерелаSzatkowski, Austin Edward. "Modeling carbon dioxide capture from a supercritical power plant with ASPEN Plus." 2009. http://gateway.proquest.com/openurl?url_ver=Z39.88-2004&rft_val_fmt=info:ofi/fmt:kev:mtx:dissertation&res_dat=xri:pqdiss&rft_dat=xri:pqdiss:1463980.
Повний текст джерелаJavaji, S. K. "Study of Dynamic Behavior of Ethyl Acetate Reactive Distillation Column Using ASPEN PLUS." Thesis, 2009. http://ethesis.nitrkl.ac.in/1532/1/10500022.pdf.
Повний текст джерелаPlaza, Jorge Mario. "Modeling of carbon dioxide absorption using aqueous monoethanolamine, piperazine and promoted potassium carbonate." Thesis, 2012. http://hdl.handle.net/2152/ETD-UT-2012-05-4952.
Повний текст джерелаtext
Tenneti, Srinivas. "Design of Auto Mix Single Stage Anaerobic Digester and Aspen Plus Simulation for Biogas Production." Thesis, 2015. http://ethesis.nitrkl.ac.in/7690/1/2015_Design_Srinivas.pdf.
Повний текст джерелаAdil, Anam. "Methanol Synthesis from Simulated Bio-syngas: Experimental and Modeling Studies." Thesis, 2023. https://etd.iisc.ac.in/handle/2005/6186.
Повний текст джерелаCheung, Miranda. "Modelling of the nickel and cobalt kinetics during pressure acid leaching of laterites using Aspen Plus 11.1TM and OLI." 2004. http://link.library.utoronto.ca/eir/EIRdetail.cfm?Resources__ID=94882&T=F.
Повний текст джерела