Livros sobre o tema "Optical indices"

India’s most difficult foreign policy challenge has been Pakistan. At one level, the relationship has been managed reasonably well given the fundamental contradiction between India’s status quo-ist approach on Kashmir and Pakistan’s determination to alter the status quo. At another, Indian policy-makers’ inability to meet the challenge effectively reflects the constraints imposed by major policy choices. Jawaharlal Nehru opted for a set of ‘independent’ strategic and economic policies that congealed into ‘non-alignment’ and ‘self-sufficiency’. This left India militarily and economically weak and unable to counter Pakistan’s sustained bid to wrest Kashmir. A later set of choices encompasses failure to anticipate the consequences of Pakistan’s acquisition of nuclear capability, reluctance to match Islamabad’s asymmetric strategy of pressurizing India, and a tendency to slip back into the autonomy-oriented policy template of the Cold War era. Consequently, India’s capacity to fashion an optimal policy towards Pakistan continues to be significantly constrained.

The article gives an overview on the concept of individualism in cognitive science. Individualism maintains that optimal human reasoning is substantially asocial, and therefore implies that sociality does not facilitate, and may impede, reasoning. The cognitive science of morality very frequently proceeds with individualist assumptions. The individualist may allow that normal development requires sociality, but deny that optimal reasoning in mature individuals requires it. The optimal cognitive functioning is both developed and sustained through sociality. The optimal exercise of rationality is a socially embedded process. It means that sociality is not just a precondition of rationality, but that even among those with normal cognitive functioning, the optimal exercise of rationality typically occurs as part of a social process. The sociality has a significant role in substantial cognitive achievement, such as scientific and technological discovery. A large body of research indicates that motivation plays a crucial role in reasoning. The optimal human reasoning is substantially asocial, and sociality is necessary for the development of optimal reasoning. The sociality is necessary for the sustenance of optimal reasoning, and for the transmission of information. One important feature of group interactions is that they are likely to induce emotional responses. Many familiar emotions such as anger, guilt, and sympathy are characteristically triggered by cues in social interaction.

The performance index for an optimal spacecraft trajectory is typically minimum propellant consumption, not because of the monetary cost of the propellant, but because for each kilogram of propellant saved an additional kilogram of payload is delivered to the final destination. The term “minimum fuel” is often used in place of “minimum propellant”, even for chemical rockets in which the propellant is composed of both fuel and oxidizer. As is often the case, the term “fuel” is used rather than “propellant” because it’s shorter – having one syllable instead of three. In some applications other performance indices are used, such as minimum time, maximum range, etc....

Chapter 9, Approaches to Programming, provided a general discussion regarding the approaches to DBS programming. The focus of Chapter 9 was on the underlying electroneurophysiological principles rather an explicit algorithm that addressed every possible circumstance. Chapters 11, Chapter 12, and Chapter 13 discussed approaches in the context of specific DBS targets. These approaches emphasized interpreting the DBS responses to visualize the location of the DBS contacts in the unique regional anatomy of the individual patient. For example, the production of paresthesias at stimulation currents insufficient to produce clinical benefit with DBS in the vicinity of the STN indicates that the DBS lead position is probably too posterior. This chapter gives an algorithm that takes the programmer step by step through the process of positioning DBS leads and contacts, and determining stimulation levels for optimal results.

The complexity of fish behaviour and information processing indicates high levels of neural, anatomical and functional organization. Neural cells are conducting neurons and neuroglia with putative support and physiological roles. Neuronal conduction, synaptic transmission, reflexes and neuropils are factors in integrative activity and information processing. Fish nervous systems are organized into central (brain and spinal cord) and peripheral (including autonomic) components. Interestingly the structure and function of the fish optic tectum have been considered comparable to those of the tetrapod cerebral cortex. Also of interest are the bilaterally paired large Mauthner fibres in the teleost central nervous system, which mediate startle responses. The autonomic nervous system in fish occupies a pivotal position amongst vertebrates, including uncertainty about the existence of a posterior parasympathetic component. The trend is to regard it in terms of spinal autonomic (sympathetic) cranial autonomic (parasympathetic) and enteric systems. Accounts of the autonomic control of individual effector systems are included.

The aim of the study was to compare a patch-mosaic pattern in the old-growth forest stands developed in various climate and soil conditions occurring in different regions of Poland. Based on the assumption, that the patch-mosaic pattern in the forest reflect the dynamic processes taking place in it, and that each type of forest ecosystem is characterized by a specific regime of natural disturbances, the following hypotheses were formulated: (i) the patches with a complex structure in stands composed of latesuccessional, shade-tolerant tree species are more common than those composed of early-successional, light-demanding ones, (ii) the patch-mosaic pattern is more heterogeneous in optimal forest site conditions than in extreme ones, (iii) in similar site conditions differentiation of the stand structure in distinguished patches is determined by the successional status of the tree species forming a given patch, (iv) the successional trends leading to changes of species composition foster diversification of the patch structure, (v) differentiation of the stand structure is negatively related to their local basal area, especially in patches with a high level of its accumulation. Among the best-preserved old-growth forest remaining under strict protection in the Polish national parks, nineteen research plots of around 10 ha each were selected. In each plot, a grid (50 × 50 m) of circular sample subplots (with radius 12,62 m) was established. In the sample subplots, species and diameter at breast height of living trees (dbh ≥ 7 cm) were determined. Subsequently, for each sample subplot, several numerical indices were calculated: local basal area (G), dbh structure differentiation index (STR), climax index (CL) and successional index (MS). Statistical tests of Kruskal- Wallis, Levene and Generalized Additive Models (GAM) were used to verify the hypotheses. All examined forests were characterized by a large diversity of stand structure. A particularly high frequency of highly differentiated patches (STR > 0,6) was recorded in the alder swamp forest. The patch mosaic in the examined plots was different – apart from the stands with a strongly pronounced mosaic character (especially subalpine spruce forests), there were also stands with high spatial homogeneity (mainly fir forests). The stand structure in the distinguished patches was generally poorly related to the other studied features. Consequently, all hypotheses were rejected. These results indicate a very complex, mixed pattern of forest natural dynamics regardless of site conditions. In beech forests and lowland multi-species deciduous forests, small-scale disturbances of the gap dynamics type dominate, which are overlapped with less frequent medium-scale disturbances. In more difficult site conditions, large-scale catastrophic disturbances, which occasionally appear in communities formed under the influence of gap dynamics (mainly spruce forests) or cohort dynamics (mainly pine forests), gain importance.

The aim of the paper was to determine the influence of root systems of chosen tree species found in the Polish Flysch Carpathians on the increase of soil shear strength (root cohesion) in terms of slope stability. The paper's goal was achieved through comprehensive tests on root systems of eight relatively common in the Polish Flysch Carpathians tree species. The tests that were carried out included field work, laboratory work and analytical calculations. As part of the field work, the root area ratio (A IA) of the roots was determined using the method of profiling the walls of the trench at a distance of about 1.0 m from the tree trunk. The width of the. trenches was about 1.0 m, and their depth depended on the ground conditions and ranged from 0.6 to 1.0 m below the ground level. After preparing the walls of the trench, the profile was divided into vertical layers with a height of 0.1 m, within which root diameters were measured. Roots with diameters from 1 to 10 mm were taken into consideration in root area ratio calculations in accordance with the generally accepted methodology for this type of tests. These measurements were made in Biegnik (silver fir), Ropica Polska (silver birch, black locust) and Szymbark (silver birch, European beech, European hornbeam, silver fir, sycamore maple, Scots pine, European spruce) located near Gorlice (The Low Beskids) in areas with unplanned forest management. In case of each tested tree species the samples of roots were taken, transported to the laboratory and then saturated with water for at least one day. Before testing the samples were obtained from the water and stretched in a. tensile testing machine in order to determine their tensile strength and flexibility. In general, over 2200 root samples were tested. The results of tests on root area ratio of root systems and their tensile strength were used to determine the value of increase in shear strength of the soils, called root cohesion. To this purpose a classic Wu-Waldron calculation model was used as well as two types of bundle models, the so called static model (Fiber Bundle Model — FIRM, FBM2, FBM3) and the deformation model (Root Bundle Model— RBM1, RBM2, mRBM1) that differ in terms of the assumptions concerning the way the tensile force is distributed to the roots as well as the range of parameters taken into account during calculations. The stability analysis of 8 landslides in forest areas of Cicikowicleie and Wignickie Foothills was a form of verification of relevance of the obtained calculation results. The results of tests on root area ratio in the profile showed that, as expected, the number of roots in the soil profile and their ApIA values are very variable. It was shown that the values of the root area ratio of the tested tree species with a diameter 1-10 ram are a maximum of 0.8% close to the surface of the ground and they decrease along with the depth reaching the values at least one order of magnitude lower than close to the surface at the depth 0.5-1.0 m below the ground level. Average values of the root area ratio within the soil profile were from 0.05 to 0.13% adequately for Scots pine and European beech. The measured values of the root area ratio are relatively low in relation to the values of this parameter given in literature, which is probably connected with great cohesiveness of the soils and the fact that there were a lot of rock fragments in the soil, where the tests were carried out. Calculation results of the Gale-Grigal function indicate that a distribution of roots in the soil profile is similar for the tested species, apart from the silver fir from Bie§nik and European hornbeam. Considering the number of roots, their distribution in the soil profile and the root area ratio it appears that — considering slope stability — the root systems of European beech and black locust are the most optimal, which coincides with tests results given in literature. The results of tensile strength tests showed that the roots of the tested tree species have different tensile strength. The roots of European beech and European hornbeam had high tensile strength, whereas the roots of conifers and silver birch in deciduous trees — low. The analysis of test results also showed that the roots of the studied tree species are characterized by high variability of mechanical properties. The values Of shear strength increase are mainly related to the number and size (diameter) of the roots in the soil profile as well as their tensile strength and pullout resistance, although they can also result from the used calculation method (calculation model). The tests showed that the distribution of roots in the soil and their tensile strength are characterized by large variability, which allows the conclusion that using typical geotechnical calculations, which take into consideration the role of root systems is exposed to a high risk of overestimating their influence on the soil reinforcement. hence, while determining or assuming the increase in shear strength of soil reinforced with roots (root cohesion) for design calculations, a conservative (careful) approach that includes the most unfavourable values of this parameter should be used. Tests showed that the values of shear strength increase of the soil reinforced with roots calculated using Wu-Waldron model in extreme cases are three times higher than the values calculated using bundle models. In general, the most conservative calculation results of the shear strength increase were obtained using deformation bundle models: RBM2 (RBMw) or mRBM1. RBM2 model considers the variability of strength characteristics of soils described by Weibull survival function and in most cases gives the lowest values of the shear strength increase, which usually constitute 50% of the values of shear strength increase determined using classic Wu-Waldron model. Whereas the second model (mRBM1.) considers averaged values of roots strength parameters as well as the possibility that two main mechanism of destruction of a root bundle - rupture and pulling out - can occur at the same. time. The values of shear strength increase calculated using this model were the lowest in case of beech and hornbeam roots, which had high tensile strength. It indicates that in the surface part of the profile (down to 0.2 m below the ground level), primarily in case of deciduous trees, the main mechanism of failure of the root bundle will be pulling out. However, this model requires the knowledge of a much greater number of geometrical parameters of roots and geotechnical parameters of soil, and additionally it is very sensitive to input data. Therefore, it seems practical to use the RBM2 model to assess the influence of roots on the soil shear strength increase, and in order to obtain safe results of calculations in the surface part of the profile, the Weibull shape coefficient equal to 1.0 can be assumed. On the other hand, the Wu-Waldron model can be used for the initial assessment of the shear strength increase of soil reinforced with roots in the situation, where the deformation properties of the root system and its interaction with the soil are not considered, although the values of the shear strength increase calculated using this model should be corrected and reduced by half. Test results indicate that in terms of slope stability the root systems of beech and hornbeam have the most favourable properties - their maximum effect of soil reinforcement in the profile to the depth of 0.5 m does not usually exceed 30 kPa, and to the depth of 1 m - 20 kPa. The root systems of conifers have the least impact on the slope reinforcement, usually increasing the soil shear strength by less than 5 kPa. These values coincide to a large extent with the range of shear strength increase obtained from the direct shear test as well as results of stability analysis given in literature and carried out as part of this work. The analysis of the literature indicates that the methods of measuring tree's root systems as well as their interpretation are very different, which often limits the possibilities of comparing test results. This indicates the need to systematize this type of tests and for this purpose a root distribution model (RDM) can be used, which can be integrated with any deformation bundle model (RBM). A combination of these two calculation models allows the range of soil reinforcement around trees to be determined and this information might be used in practice, while planning bioengineering procedures in areas exposed to surface mass movements. The functionality of this solution can be increased by considering the dynamics of plant develop¬ment in the calculations. This, however, requires conducting this type of research in order to obtain more data.