Literatura académica sobre el tema "Injection-Locked Oscillator (ILO)"
Crea una cita precisa en los estilos APA, MLA, Chicago, Harvard y otros
Consulte las listas temáticas de artículos, libros, tesis, actas de conferencias y otras fuentes académicas sobre el tema "Injection-Locked Oscillator (ILO)".
Junto a cada fuente en la lista de referencias hay un botón "Agregar a la bibliografía". Pulsa este botón, y generaremos automáticamente la referencia bibliográfica para la obra elegida en el estilo de cita que necesites: APA, MLA, Harvard, Vancouver, Chicago, etc.
También puede descargar el texto completo de la publicación académica en formato pdf y leer en línea su resumen siempre que esté disponible en los metadatos.
Artículos de revistas sobre el tema "Injection-Locked Oscillator (ILO)"
Abdul-Niby, M., M. Alameen y H. Baitie. "A Simple Phase Shifting Technique for an Injection Locked Oscillator". Engineering, Technology & Applied Science Research 6, n.º 6 (18 de diciembre de 2016): 1303–6. http://dx.doi.org/10.48084/etasr.881.
Texto completoMao, Yuqing, Yoann Charlon, Yves Leduc y Gilles Jacquemod. "A Low Power Injection-Locked CDR Using 28 nm FDSOI Technology for Burst-Mode Applications". Journal of Low Power Electronics and Applications 14, n.º 2 (7 de abril de 2024): 22. http://dx.doi.org/10.3390/jlpea14020022.
Texto completoAbbasizadeh, Hamed, Sang Yun Kim, Behnam Samadpoor Rikan, Arash Hejazi, Danial Khan, Young Gun Pu, Keum Cheol Hwang, Youngoo Yang, Dong In Kim y Kang-Yoon Lee. "Design of a 900 MHz Dual-Mode SWIPT for Low-Power IoT Devices". Sensors 19, n.º 21 (28 de octubre de 2019): 4676. http://dx.doi.org/10.3390/s19214676.
Texto completoTesis sobre el tema "Injection-Locked Oscillator (ILO)"
Mao, Yuqing. "Nouvelle génération de générateurs de fréquence par auto-calibration de la grille arrière des transistors en technologie FDSOI". Electronic Thesis or Diss., Université Côte d'Azur, 2023. http://www.theses.fr/2023COAZ4123.
Texto completoModern data communication systems heavily rely on synchronous transmission techniques to optimize bandwidth and minimize power consumption. In such systems, only the data signal is transmitted, necessitating the implementation of Clock and Data Recovery (CDR) circuits at the receiver end. This thesis explores the novel application of Fully-Depleted Silicon-On-Insulator (FDSOI) 28nm technology to enhance the performance of CDR circuits by mitigating short-channel effects through innovative transistor structures.One contribution of this thesis is the development of a negative resistance circuit using the back gate of the FDSOI transistor. This circuit employs a current mirror controlled by the back gate to create a negative resistance LC oscillator. In parallel, this work presents the implementation of two types of oscillators: a complementary ring oscillator and a fast ring oscillator. The complementary ring oscillator capitalizes on complementary inverters, offering automatic bias feedback by the back gate control, thereby enhancing its performance. Meanwhile, the fast ring oscillator uses fast inverters in combination with complementary inverters designed to minimize propagation delays. The thesis presents a detailed comparative analysis of these oscillators, highlighting their individual strengths and limitations. Furthermore, we introduce an injection signal into the ring oscillator, resulting in the creation of a low-jitter Injection-Locked Oscillator (ILO). This ILO exhibits remarkable performance characteristics, particularly in reducing phase noise and enhancing frequency stability. Taking advantage of the good performance of the ILO, we propose a novel low-cost and low-power Injection-Locked Clock and Data Recovery (ILCDR) with a fast-locking time and good jitter for burst-mode applications.To validate the proposed designs and their performance at different operational frequencies, extensive simulations have been carried out using Cadence Virtuoso at 868 MHz and 2.4 GHz. In addition, the layout design and post layout simulation of the ILCDR based on the complementary ring oscillator are also studied
"An injection locked oscillator (ILO): regenerative mixer". Chinese University of Hong Kong, 1995. http://library.cuhk.edu.hk/record=b5888534.
Texto completoThesis (M.Phil.)--Chinese University of Hong Kong, 1995.
Includes bibliographical references (leaves [121]-[125]).
DEDICATION
ACKNOWLEDGE
ABSTRACT
Chapter Chapter 1 --- Introduction --- p.1-1
Chapter Chapter 2 --- Background --- p.2-1
Chapter 2.1 --- Basic Oscillator --- p.2-2
Chapter 2.1.1 --- Introduction --- p.2-2
Chapter 2.1.2 --- The basic feedback oscillator --- p.2-2
Chapter 2.1.3 --- The basic negative resistance oscillator --- p.2-3
Chapter 2.1.4 --- Implementation of an oscillator --- p.2-3
Chapter 2.1.5 --- The phase noise of an oscillator --- p.2-4
Chapter a) --- Lesson's model --- p.2-4
Chapter 2.2 --- Basic Mixer --- p.2-6
Chapter 2.2.1 --- Introduction --- p.2-6
Chapter 2.2.2 --- Non-linear resistance mixer --- p.2-6
Chapter 2.2.3 --- Y-parameter representation --- p.2-7
Chapter 2.2.4 --- Figure of merit --- p.2-9
Chapter 2.3 --- Negative Resistance Amplifier --- p.2-11
Chapter 2.3.1 --- Introdutction --- p.2-12
Chapter 2.3.2 --- Type of reflection amplifier --- p.2-12
Chapter 2.3.3 --- The noise figure --- p.2-13
Chapter 2.4 --- Fundamental Injection-locked Oscillator --- p.2-15
Chapter 2.4.1 --- Introduction --- p.2-15
Chapter 2.4.2 --- Injection-locked oscillator --- p.2-15
Chapter 2.4.3. --- Locking range --- p.2-15
Chapter 2.4.4 --- Noise behaviour --- p.2-16
Chapter 2.4.5 --- Applications of ILO --- p.2-17
Chapter 2.5 --- Quasi-static analysis --- p.2-18
Chapter 2.5.1 --- Introduction --- p.2-18
Chapter 2.5.2 --- free running oscillation --- p.2-18
Chapter 2.5.3 --- Conditions for injection locking --- p.2-22
Chapter a) --- Stability --- p.2-24
Chapter 2.5.4 --- Conditions for Two signal injection --- p.2-25
Chapter a) --- Stability --- p.2-26
Chapter Chapter 3 --- Frequency conversion of Injection-locked oscillator --- p.3-1
Chapter 3.1 --- Circuit Description --- p.3 -2
Chapter 3.1.1 --- One port equivalent circuit --- p.3-5
Chapter 3.1.2 --- Two port equivalent circuit --- p.3-6
Chapter 3.2 --- Injection Control Resistance --- p.3-7
Chapter 3.2.1 --- Introduction --- p.3-7
Chapter 3.2.2 --- Measurement Setup --- p.3-8
Chapter 3.2.3 --- Measurement and Experimental results --- p.3-9
Chapter 3.2.4 --- Discussion --- p.3-11
Chapter 3.2.5 --- Conclusion --- p.3-11
Chapter 3.3 --- Q Multiplication --- p.3-12
Chapter 3.3.1 --- Introduction --- p.3-12
Chapter 3.3.1 --- Measurement setup of reflection gain/loss --- p.3-16
Chapter a) --- Theory of measurement --- p.3-16
Chapter 3.3.3 --- Measurement and Experiment results --- p.3-17
Chapter 3.3.4 --- Discussion --- p.3-17
Chapter 3.3.5 --- Conclusion --- p.3-19
Chapter 3.4 --- Impedance Conversion --- p.3-20
Chapter 3.4.1 --- Introduction --- p.3-20
Chapter 3.4.2 --- Measurement and Experimental results --- p.3-22
Chapter 3.4.3 --- Discussion --- p.3-26
Chapter 3.4.5 --- Conclusion --- p.3-26
Chapter 3.5 --- Negative Resistance amplification --- p.3-27
Chapter 3.5.1 --- Introduction --- p.3-27
Chapter a) --- Small signal response --- p.3-27
Chapter 3.5.2 --- Measurement and Experimental Results --- p.3-31
Chapter 3.5.3 --- Discussion --- p.3-32
Chapter 3.5.4 --- Conclusion --- p.3-35
Chapter 3.6 --- Frequency Conversion and Noise performance --- p.3-36
Chapter 3.6.1 --- Frequency Conversion --- p.3-36
Chapter 3.6.2 --- Noise performance --- p.3-37
Chapter 3.6.3 --- Measurement setup --- p.3-41
Chapter 3.6.4 --- Measurement and Experimental results --- p.3-43
Chapter a) --- Results of the sensitivity measurement --- p.3-43
Chapter b) --- Results of 3 dB operation bandwidth measurement --- p.3-44
Chapter c) --- Results of the testing setup in figure 3.6.2 --- p.3-44
Chapter 3.6.5 --- Discussion --- p.3-46
Chapter 3.6.6 --- Conclusion --- p.3-48
Chapter 3.7 --- Large Signal Response --- p.3-49
Chapter 3.7.1 --- Introduction --- p.3-49
Chapter 3.7.2 --- Measurement and Experimental results --- p.3-51
Chapter a) --- The reflection characteristics of ILO at high RF signal level
Chapter a1) --- Gain bandwidth characteristics --- p.3-51
Chapter a2) --- Gain compression characteristics --- p.3-52
Chapter b) --- The reflection characteristics of ILO at high IF signal level
Chapter b1) --- Gain bandwidth characteristics --- p.3-54
Chapter b2) --- Gain compression characteristics --- p.3-55
Chapter c) --- The conversion properties of ILO
Chapter c1) --- Gain compression characteristics --- p.3-57
Chapter 3.7.3 --- Discussion --- p.3-60
Chapter 3.7.4 --- Conclusion --- p.3-61
Chapter 3.8 --- Image Signal Response --- p.3-62
Chapter 3.8.1 --- Introduction --- p.3-62
Chapter 3.8.2 --- Measurement and Experimental results --- p.3-63
Chapter 3.8.3 --- Discussion --- p.3-65
Chapter 3.8.4 --- Conclusion --- p.3-66
Chapter 3.9 --- Conclusion --- p.3-67
Chapter Chapter 4 --- ILO Regenerative Mixer --- p.4-1
Chapter 4.1 --- Introduction --- p.4-1
Chapter 4.2 --- Block diagram representation --- p.4-1
Chapter 4.3 --- Linear Regenerative Mixer Model --- p.4-2
Chapter 4.3.1 --- Y-parameter representation --- p.4-2
Chapter 4.3.2 --- Stability --- p.4-4
Chapter 4.3.3 --- Linear circuit model --- p.4-5
Chapter 4.4 --- Design Example and Circuit Description --- p.4-6
Chapter 4.5 --- Measurement Results --- p.4-8
Chapter 4.6 --- Conclusion --- p.4-11
Chapter Chapter 5 --- Conclusion --- p.5-1
REFERENCE --- p.R-1
Actas de conferencias sobre el tema "Injection-Locked Oscillator (ILO)"
Shin, Wongyu, Seungwook Paek y Lee-Sup Kim. "An area-efficient on-chip temperature sensor with nonlinearity compensation using injection-locked oscillator (ILO)". En 2014 IEEE International Symposium on Circuits and Systems (ISCAS). IEEE, 2014. http://dx.doi.org/10.1109/iscas.2014.6865517.
Texto completo