Literatura académica sobre el tema "Ceramic multilayer system"
Crea una cita precisa en los estilos APA, MLA, Chicago, Harvard y otros
Consulte las listas temáticas de artículos, libros, tesis, actas de conferencias y otras fuentes académicas sobre el tema "Ceramic multilayer system".
Junto a cada fuente en la lista de referencias hay un botón "Agregar a la bibliografía". Pulsa este botón, y generaremos automáticamente la referencia bibliográfica para la obra elegida en el estilo de cita que necesites: APA, MLA, Harvard, Vancouver, Chicago, etc.
También puede descargar el texto completo de la publicación académica en formato pdf y leer en línea su resumen siempre que esté disponible en los metadatos.
Artículos de revistas sobre el tema "Ceramic multilayer system"
Partsch, Uwe, Adrian Goldberg, Martin Ihle, Gunter Hagen y D. Arndt. "Novel Technology Options for Multilayer-Based Ceramic Microsystems". Journal of Microelectronics and Electronic Packaging 8, n.º 3 (1 de julio de 2011): 95–101. http://dx.doi.org/10.4071/imaps.292.
Texto completoPartsch, Uwe, Adrian Goldberg, Martin Ihle, Gunter Hagen y D. Arndt. "Novel Technology Options for Multilayer-Based Ceramic Microsystems". Additional Conferences (Device Packaging, HiTEC, HiTEN, and CICMT) 2011, CICMT (1 de septiembre de 2011): 000166–71. http://dx.doi.org/10.4071/cicmt-2011-wa13.
Texto completoZiesche, Steffen, Adrian Goldberg, Uwe Partsch, Holger Kappert, Heidrun Kind, Mirko Aden y Falk Naumann. "On-turbine multisensors based on Hybrid Ceramic Manufacturing Technology". Additional Conferences (Device Packaging, HiTEC, HiTEN, and CICMT) 2019, HiTen (1 de julio de 2019): 000107–11. http://dx.doi.org/10.4071/2380-4491.2019.hiten.000107.
Texto completoCegła, Marcin. "SPECIAL CERAMICS IN MULTILAYER BALLISTIC PROTECTION SYSTEMS". PROBLEMY TECHNIKI UZBROJENIA 147, n.º 3/2018 (4 de enero de 2019): 63–74. http://dx.doi.org/10.5604/01.3001.0012.8312.
Texto completoGurauskis, Jonas, Antonio Javier Sanchez-Herencia y Carmen Baudín. "Laminated Ceramic Structures within Alumina / YTZP System Obtained by Low Pressure Joining". Key Engineering Materials 333 (marzo de 2007): 219–22. http://dx.doi.org/10.4028/www.scientific.net/kem.333.219.
Texto completoQian, Zheng Hua, Feng Jin, Zi Kun Wang y Kikuo Kishimoto. "The Horizontally Polarized Shear Waves in Multilayered Piezo-Composites with 2-2 Connectivity". Key Engineering Materials 261-263 (abril de 2004): 465–70. http://dx.doi.org/10.4028/www.scientific.net/kem.261-263.465.
Texto completoGu, Yan, Yilong Feng, Junfeng Yang, Zhifu Liu, Tong Zhuang y Yongxiang Li. "Wire-bondable multilayer ceramic capacitors". Additional Conferences (Device Packaging, HiTEC, HiTEN, and CICMT) 2016, CICMT (1 de mayo de 2016): 000183–88. http://dx.doi.org/10.4071/2016cicmt-tha14.
Texto completoWang, Yunda, Ziyang Zhang, Tomoyasu Usui, Michael Benedict, Sakyo Hirose, Joseph Lee, Jamie Kalb y David Schwartz. "A high-performance solid-state electrocaloric cooling system". Science 370, n.º 6512 (1 de octubre de 2020): 129–33. http://dx.doi.org/10.1126/science.aba2648.
Texto completoMujiyono, Mujiyono, Didik Nurhadiyanto, Alaya Fadllu Hadi Mukhammad, Tri Widodo Besar Riyadi, Kristanto Wahyudi, Nur Kholis, Asri Peni Wulandari y Shukur bin Abu Hassan. "Damage formations of ramie fiber composites multilayer armour system under high-velocity impacts". Eastern-European Journal of Enterprise Technologies 1, n.º 12 (121) (24 de febrero de 2023): 16–25. http://dx.doi.org/10.15587/1729-4061.2023.273788.
Texto completoHuang, Cheng-Liang, Jsung-Ta Tsai y Han-Shui Hsueh. "Simplified multilayer ceramic planar filter for wireless communication system". Microwave and Optical Technology Letters 25, n.º 4 (20 de mayo de 2000): 233–35. http://dx.doi.org/10.1002/(sici)1098-2760(20000520)25:4<233::aid-mop2>3.0.co;2-s.
Texto completoTesis sobre el tema "Ceramic multilayer system"
PADOVANO, ELISA. "Ceramic multilayer based on ZrB2/SiC system for aerospace applications". Doctoral thesis, Politecnico di Torino, 2015. http://hdl.handle.net/11583/2599760.
Texto completoZhou, Yijun. "Polymer-Ceramic Composites for Conformal Multilayer Antenna and RF Systems". The Ohio State University, 2009. http://rave.ohiolink.edu/etdc/view?acc_num=osu1245240041.
Texto completoSalamone, Sam. "Densification of and constitutive laws for ceramic matrix composites and multilayered systems /". Thesis, Connect to this title online; UW restricted, 2003. http://hdl.handle.net/1773/10585.
Texto completoZhang, Wenli. "HIGH PERFORMANCE PIEZOELECTRIC MATERIALS AND DEVICES FOR MULTILAYER LOW TEMPERATURE CO-FIRED CERAMIC BASED MICROFLUIDIC SYSTEMS". UKnowledge, 2011. http://uknowledge.uky.edu/gradschool_diss/200.
Texto completoKeng-RenLin y 林耕任. "Novel Force Sensor Array System Built with Industrial Multilayer Ceramic Capacitors for Occlusal Force Measurement". Thesis, 2012. http://ndltd.ncl.edu.tw/handle/76220322623962583118.
Texto completo國立成功大學
生物醫學工程學系
101
Chewing is the most important function of the teeth to provide essential nutrition and energy for life maintain. It has been showed that the loading force on the dental crown plays a vital role in long-term success of many dental treatments. However, the quantification of the force regarding human occlusion and mastication is still not well recognized, especially in how these forces are distributed over the dental crown. Improper distribution of the occlusal force may cause temporomandibular joint disorder, crown fracture, restoration damage, or loss of osseointegration in dental implants. A comprehensive measurement of the occlusion and mastication forces is therefore vital. This study aimed to evaluate the feasibility of developing a miniature force sensing array to measure the complicated occlusal force condition, force size, load site and direction. The multilayer ceramic capacitor (MLCC) is employed as the sensing element in this study. An MLCC element is composed of a stack of piezoelectric ceramic materials, typically using barium titanate (BaTiO3) as the dielectric layer and nickel as the conducting layer. The BaTiO3 is a general piezoelectric material providing great piezoelectric properties. A piezoelectric dielectric layer, with its top and bottom internal electrodes, can be viewed as a thin piezoelectric transducer unit. However, industrial-grade MLCC is used as capacitor rather than as force sensing components. The force sensitivity among different MLCCs can varied by 70%. A simple re-poling process was developed to pole the sensor to a saturation situation for normalization each MLCC. A force sensing array is then developed to evaluate the possibility of measuring the complete occlusal force information. Measurement results showed that a single MLCC force sensor with a cross section area of 2.4 mm2 can withstand load up to 600 N, suitable to bear the large occlusion force. The piezoelectric constant could be increased from 19 pC/N to 1,740 pC/N after re-poling while the variation could be reduced down to 6%. This indicated that the normalized MLCC provides good force response and excellent repeatability. More importantly, there was no time lag for dynamic force measurements. Two sheets of force sensor array, each composed of 4x4 re-poled MLCC elements soldered on a flexible circuit sheet, were embedded into a temporary crown to measure, in-vitro, the occlusion force. The first sensor array was integrated with the crown near the occlusal surface to identify the loaded site. The second sheet was placed under the bottom surface of the crown to measure the total force size as well as the distribution. The directions of each occlusal force could then be obtained from the simulation of a finite element analysis. This indirect measurement approach confirms that a simple and inexpensive MLCC-based force sensor system is feasible to investigate the complicated occlusal loading. This system has great potential to be developed for applications in both clinical and biomedical engineering.
Capítulos de libros sobre el tema "Ceramic multilayer system"
Takagi, Hiroshi. "Recent Progress in Multilayer Ceramic Devices". En Advances in Multifunctional Materials and Systems, 43–54. Hoboken, NJ, USA: John Wiley & Sons, Inc., 2010. http://dx.doi.org/10.1002/9780470909850.ch5.
Texto completoCzekaj, Dionizy, Julian Dudek, Zygmunt Surowiak, Aleksandr V. Gorish, Yuri N. Koptev, Aleksandr A. Kuprienko y Anatoli E. Panich. "Multilayer Piezoelectric Sensors on the Basis of The PZT Type Ceramics". En Mixed Design of Integrated Circuits and Systems, 91–96. Boston, MA: Springer US, 1998. http://dx.doi.org/10.1007/978-1-4615-5651-0_14.
Texto completoSobocinski, M., J. Putaala y H. Jantunen. "Multilayer low-temperature co-fired ceramic systems incorporating a thick-film printing process". En Printed Films, 134–64. Elsevier, 2012. http://dx.doi.org/10.1533/9780857096210.1.134.
Texto completoActas de conferencias sobre el tema "Ceramic multilayer system"
Vaughan, B. A. M. "Spall Strength of Ceramic in a Multilayer System". En Shock Compression of Condensed Matter - 2001: 12th APS Topical Conference. AIP, 2002. http://dx.doi.org/10.1063/1.1483645.
Texto completoJiaoying Huang, Yongkang Wan, Cheng Gao y Yuanyuan Xiong. "Discussion on multilayer ceramic replacements for tantalum capacitors". En 2015 Prognostics and System Health Management Conference (PHM). IEEE, 2015. http://dx.doi.org/10.1109/phm.2015.7380064.
Texto completoAhmar, Joseph Al y Steffen Wiese. "Fracture mechanics analysis of cracks in multilayer ceramic capacitors". En 2014 Electronics System-Integration Technology Conference (ESTC). IEEE, 2014. http://dx.doi.org/10.1109/estc.2014.6962828.
Texto completoTseng, Chun-chieh, Mao-fu Lai y Por-song Lee. "Image Inspection System for Defect Detection of Multilayer Ceramic Capacitors". En 2006 International Conference on Intelligent Information Hiding and Multimedia. IEEE, 2006. http://dx.doi.org/10.1109/iih-msp.2006.265088.
Texto completoAhmar, Joseph Al, Erik Wiss y Steffen Wiese. "Flex Cracking of Multilayer Ceramic Capacitors: Experiments on Fracture Propagation". En 2018 7th Electronic System-Integration Technology Conference (ESTC). IEEE, 2018. http://dx.doi.org/10.1109/estc.2018.8546356.
Texto completoHrbud, Ivana, M. Rose y Patrick White. "Performance of a multilayer ceramic capacitor power system for pulsed plasma thrusters". En 34th AIAA/ASME/SAE/ASEE Joint Propulsion Conference and Exhibit. Reston, Virigina: American Institute of Aeronautics and Astronautics, 1998. http://dx.doi.org/10.2514/6.1998-3802.
Texto completoTakato, M., T. Nishi, M. Kaneko, J. Tanida, S. Tada, K. Saito y F. Uchikoba. "Multilayer ceramic coil for wireless power transfer system by photo resist film process". En 2014 International Conference on Electronics Packaging (ICEP). IEEE, 2014. http://dx.doi.org/10.1109/icep.2014.6826705.
Texto completoGoldberg, Adrian, Carsten Pohlmann, Lars Rontzsch, Christian Freitag, Ariel Thierry Tagne Saha, Steffen Ziesche y Uwe Partsch. "Highly efficient and long-term stable micro fuel cell system based on ceramic multilayer technology". En 2016 6th Electronic System-Integration Technology Conference (ESTC). IEEE, 2016. http://dx.doi.org/10.1109/estc.2016.7764494.
Texto completoFloristán, M., R. Gadow y A. Killinger. "Electrically Conductive Plasma Sprayed Oxide-Metal Coatings on Glass Ceramic Substrates". En ITSC2009, editado por B. R. Marple, M. M. Hyland, Y. C. Lau, C. J. Li, R. S. Lima y G. Montavon. ASM International, 2009. http://dx.doi.org/10.31399/asm.cp.itsc2009p0612.
Texto completoLin, Keng-Ren, Cheng-Hung Chiang, Chih-Han Chang y Che-Hsin Lin. "Development of a novel force sensor system built with an industrial multilayer ceramic capacitor (MLCC)". En 2012 7th IEEE International Conference on Nano/Micro Engineered and Molecular Systems (NEMS). IEEE, 2012. http://dx.doi.org/10.1109/nems.2012.6196823.
Texto completo