Literatura académica sobre el tema "Catalysis, Ageing, STM"
Crea una cita precisa en los estilos APA, MLA, Chicago, Harvard y otros
Consulte las listas temáticas de artículos, libros, tesis, actas de conferencias y otras fuentes académicas sobre el tema "Catalysis, Ageing, STM".
Junto a cada fuente en la lista de referencias hay un botón "Agregar a la bibliografía". Pulsa este botón, y generaremos automáticamente la referencia bibliográfica para la obra elegida en el estilo de cita que necesites: APA, MLA, Harvard, Vancouver, Chicago, etc.
También puede descargar el texto completo de la publicación académica en formato pdf y leer en línea su resumen siempre que esté disponible en los metadatos.
Artículos de revistas sobre el tema "Catalysis, Ageing, STM"
Soto Beobide, Amaia, Anastasia M. Moschovi, Georgios N. Mathioudakis, Marios Kourtelesis, Zoi G. Lada, Konstantinos S. Andrikopoulos, Labrini Sygellou, Vassilios Dracopoulos, Iakovos Yakoumis y George A. Voyiatzis. "High Catalytic Efficiency of a Nanosized Copper-Based Catalyst for Automotives: A Physicochemical Characterization". Molecules 27, n.º 21 (31 de octubre de 2022): 7402. http://dx.doi.org/10.3390/molecules27217402.
Texto completoGiuliano, Mattia, Maria Carmen Valsania, Pierfrancesco Ticali, Enrico Sartoretti, Sara Morandi, Samir Bensaid, Gabriele Ricchiardi y Mauro Sgroi. "Characterization of the Evolution of Noble Metal Particles in a Commercial Three-Way Catalyst: Correlation between Real and Simulated Ageing". Catalysts 11, n.º 2 (12 de febrero de 2021): 247. http://dx.doi.org/10.3390/catal11020247.
Texto completoNeha, Neha, Ram Prasad y Satya Vir Singh. "Simultaneous Catalytic Oxidation of a Lean Mixture of CO-CH4 over Spinel Type Cobalt Based Oxides". Bulletin of Chemical Reaction Engineering & Catalysis 15, n.º 2 (12 de junio de 2020): 490–500. http://dx.doi.org/10.9767/bcrec.15.2.6499.490-500.
Texto completoNavarro-Espinoza, Sofía, Diana Meza-Figueroa, Roberto Guzmán, Alberto Duarte-Moller, Hilda Esparza-Ponce, Francisco Paz-Moreno, Belem González-Grijalva et al. "Release of Nanoparticles in the Environment and Catalytic Converters Ageing". Nanomaterials 11, n.º 12 (16 de diciembre de 2021): 3406. http://dx.doi.org/10.3390/nano11123406.
Texto completoManaila, Elena, Maria Stelescu y Gabriela Craciun. "Degradation Studies Realized on Natural Rubber and Plasticized Potato Starch Based Eco-Composites Obtained by Peroxide Cross-Linking". International Journal of Molecular Sciences 19, n.º 10 (20 de septiembre de 2018): 2862. http://dx.doi.org/10.3390/ijms19102862.
Texto completoHsu, Hsiu-Ling y Rima D. Alharthy. "Enhanced Room-Temperature Catalytic Decomposition of Cumene Hydroperoxide into Phenol and Acetone". Science of Advanced Materials 13, n.º 7 (1 de julio de 2021): 1246–52. http://dx.doi.org/10.1166/sam.2021.4001.
Texto completoArroyo-Lamas, Nagore, Iciar Arteagoitia y Unai Ugalde. "Surface Activation of Titanium Dental Implants by Using UVC-LED Irradiation". International Journal of Molecular Sciences 22, n.º 5 (5 de marzo de 2021): 2597. http://dx.doi.org/10.3390/ijms22052597.
Texto completoTesis sobre el tema "Catalysis, Ageing, STM"
Blasetti, Cecilia. "Extensive oxidation treatments: ageing effects on a catalytic model system studied in UHV by STM". Doctoral thesis, Università degli studi di Trieste, 2009. http://hdl.handle.net/10077/3096.
Texto completoThis thesis concerns a surface science approach for the investigation of the ageing process of a model catalyst. It combines extreme oxidation conditions with Ultra High Vacuum (UHV) compatible characterization techniques. Our model system was the surface oxide formed on Rh(110); to grow such oxide, we used three alternative oxygen sources, optimizing for each case the preparation recipe. When dosing molecular oxygen, pressures in the ∼ 10− 4 mbar range were used, therefore bridging, to some extent, the pressure gap. For characterization of the oxides we used mainly Scanning Tunneling Microscopy (STM) and Thermal Desorption Spectroscopy (TDS), providing atomic scale and desorption mechanism information, respectively. Low Energy Electron Microscopy (LEEM) and X-ray Photoelectron Specroscopy (XPS) complemented our measurements with large scale morphology and reactivity data and with chemically resolved results. To mimic real catalytic conditions, we setup an ageing protocol consisting of cycles of oxidation and annealing in UHV (up to more than ∼ 40), with each of the three oxygen sources. In this way, we were able to observe two different kinds of ageing: a “contaminant-driven” and an “intrinsic” one, caused by the iterative oxidation procedure. The latter is connected to the presence of a new species we detected on the (1 × 1) surface obtained after the oxide desorption, that we named “units” (or ageing fingerprints). By decreasing their number we were able to show that the intrinsic ageing is, at least partially, reversible. We could not uniquely determine the structure of the “units”, but plausible models are proposed. ------------------------------------------------
Questa tesi si occupa dello studio dell’invecchiamento artificiale di un catalizzatore modello, combinando condizioni di ossidazione estreme con le tecniche di caratterizzazione, compatibili con l’ultra-alto-vuoto (UHV), proprie della scienza delle superfici. Il nostro sistema modello era l’ossido superficiale formato sul Rh(110); per crescere questo ossido, abbiamo utilizzato tre sorgenti alternative di ossigeno, ed abbiamo ottimizzato la ricetta di preparazione nei singoli casi. Utilizzando l’ossigeno molecolare abbiamo dosato a pressioni dell’ordine di ca. 10− 4 mbar, ed in questo modo abbiamo in parte colmato la “pressure gap” che solitamente divide gli studi su sistemi modello da quelli di catalisi reale. Per caratterizzare gli ossidi abbiamo usato principalmente la microscopia a scansione ad effetto tunnel STM e la spettroscopia di desorbimento termico TDS, che ci hanno fornito rispettivamente informazioni su scala atomica e sul meccanismo di desorbimento. Le tecniche LEEM e XPS hanno contribuito in modo complementare alle nostre misure con dati di morfologia e reattività su larga scala, da un lato, e con dati risolti chimicamente, dall’altro. Per simulare le condizioni della catalisi reale, abbiamo sviluppato un protocollo di invecchiamento (“ageing”) composto da cicli di ossidazione e riscaldamento in ultra-alto-vuoto (fino a ca. 40), con ognuna delle tre sorgenti di ossigeno. Seguendo questa procedura, abbiamo osservato due diversi tipi di invecchiamento dell’ossido di rodio: un primo tipo dominato dalla presenza di contaminanti, ed un secondo invece che abbiamo chiamato “intrinseco”, causato cioè dalle ripetute ossidazioni. Quest’ultimo dipende dalla presenza di una nuova specie osservata sulla superficie (1 × 1) che si ottiene a seguito del desorbimento di ciascun ossido, che abbiamo chiamato “units” (o -ageing fingerprint-). Ri- ducendo la densità di questa specie siamo stati in grado di mostrare come l’invecchiamento intrinseco sia, almeno in parte, reversibile. Non abbiamo potuto determinare univocamente la struttura delle “units”, ma alcuni modelli possibili vengono proposti.
XXI Ciclo
1981
Capítulos de libros sobre el tema "Catalysis, Ageing, STM"
Antonio-Cruz, Rocío, Nora Alicia Purata-Pérez, María Berzabé Vázquez-González y Radamés Trejo-Valencia. "Remediation of soils contaminated by hydrocarbons using a polymeric material (carboxymethylcellulose gel)". En CIERMMI Women in Science Engineering and Technology TXV, 99–111. ECORFAN, 2021. http://dx.doi.org/10.35429/h.2021.6.99.111.
Texto completo