Academic literature on the topic 'SrFeO2.75'

The support material can play an important role in oxidation catalysis, notably for CO oxidation. Here, we study two materials of the Brownmillerite family, CaFeO2.5 and SrFeO2.5, as one example of a stoichiometric phase (CaFeO2.5, CFO) and one existing in different modifications (SrFeO2.75, SrFeO2.875 and SrFeO3, SFO). The two materials are synthesized using two synthesis methods, one bottom-up approach via a complexation route and one top-down method (electric arc fusion), allowing to study the impact of the specific surface area on the oxygen mobility and catalytic performance. CO oxidation on 18O-exchanged materials shows that oxygen from SFO participates in the reaction as soon as the reaction starts, while for CFO, this onset takes place 185 °C after reaction onset. This indicates that the structure of the support material has an impact on the catalytic performance. We report here on significant differences in the catalytic activity linked to long-term stability of CFO and SFO, which is an important parameter not only for possible applications, but equally to better understand the mechanism of the catalytic activity itself.

We have prepared a high quality single crystal of SrFeO3-δ (δ ~ 0.14) by the floating-zone method to study the electronic and atomic structures using temperature-dependent x-ray absorption near-edge structure (XANES), x-ray linear dichroism (XLD), and extended x-ray absorption fine structure (EXAFS) at the O K-edge, Fe L3,2- and K-edge. Resistivity measurements indicate that the SrFeO2.86 shows an anisotropic behavior, and thermal hysteresis behavior between 70 K and 40 K. The temperature dependent Fe K-edge EXAFS studies shows that the Fe-O bond length changes in ab-plane below transition temperature. The XLD results illustrate that as temperature is reduced from room temperature to below the transition temperature, the preferential occupancy of Fe majority-spin eg orbitals changes from the 3d3z2-r2 to 3dx2-y2, but restore to 3dx2-y2 after thermal hysteresis. Experimental findings suggest that the charge transfer during thermal hysteresis is induced by lattice distortions of the FeO6 octahedra in SrFeO2.86.

Resistance random access memory (RRAM) is attractive as a next-generation form of nonvolatile memory. We investigated an electric field-induced resistance change of SrFeO2+x film as a candidate for RRAM material. SrFeO2.5-x film prepared at 300 oC showed hysteresis in its current-voltage curve and distinct pulse-switching properties. On the other hand, the sample prepared below 280 oC showed hysteresis in its current-voltage curve but didn’t show pulse-switching properties. The amount of oxygen in the sample and easiness of oxygen migration play important roles in the resistance-switching properties.

Non-stoichiometric strontium iron oxide is described by an abbreviated formula SrFeOx (2.5 ≤ x ≤ 3.0) exhibits a variety of interesting physical and chemical properties over a broad range of temperatures and in different gaseous environments. The oxide contains a mixture of iron in the trivalent and the rare tetravalent state. The material at elevated temperature is a mixed oxygen conductor and it, or its derivatives,can have practical applications in oxygen conducting devices such as pressure driven oxygen generators, partial oxidation reactors in electrodes for solid oxide fuel cells (SOFC). ¶ This thesis examines the behaviour of the material at ambient and elevated temperatures using a broad spectrum of solid state experimental techniques such as: x-ray and neutron powder diffraction,thermogravimetric and calorimetric methods,scanning electron microscopy and Mossbauer spectroscopy. Changes in the oxide were induced using conventional thermal treatment in various atmospheres as well as mechanical energy (ball milling). The first experimental chapter examines the formation of the ferrite from a mixture of reactants.It describes the chemical reactions and phase transitions that lead to the formation of the oxide. Ball milling of the reactants prior to annealing was found to eliminate transient phases from the reaction route and to increase the kinetics of the reaction at lower temperatures. Examination of the thermodynamics of iron oxide (hematite) used for the reactions led to a new route of synthesis of the ferrite frommagnetite and strontium carbonate.This chapter also explores the possibility of synthesis of the material at room temperature using ball milling. ¶ The ferrite strongly interacts with the gas phase so its behaviour was studied under different pressures of oxygen and in carbon dioxide.The changes in ferrite composition have an equilibrium character and depend on temperature and oxygen concentration in the atmosphere. Variations of the oxygen content x were described as a function of temperature and oxygen partial pressure, the results were used to plot an equilibrium composition diagram. The heat of oxidation was also measured as a function of temperature and oxygen partial pressure. ¶ Interaction of the ferrite with carbon dioxide below a critical temperature causes decomposition of the material to strontium carbonate and SrFe12O19 . The critical temperature depends on the partial pressure of CO2 and above the critical temperature the carbonate and SrFe12O19 are converted back into the ferrite.The resulting SrFe12O19 is very resistant towards carbonation and the thermal carbonation reaction does not lead to a complete decomposition of SrFeOx to hematite and strontium carbonate. ¶ The thermally induced oxidation and carbonation reactions cease at room temperature due to sluggish kinetics however,they can be carried out at ambient temperature using ball milling.The reaction routes for these processes are different from the thermal routes.The mechanical oxidation induces two or more concurrent reactions which lead to samples containing two or more phases. The mechanical carbonation on the other hand produces an unknown metastable iron carbonate and leads a complete decomposition of the ferrite to strontiumcarbonate and hematite. ¶ Thermally and mechanically oxidized samples were studied using Mossbauer spectroscopy. The author proposes a new interpretation of the Sr4Fe4O11 (x=2.75) and Sr8Fe8O23 (x=2.875)spectra.The interpretation is based on the chemistry of the compounds and provides a simpler explanation of the observed absorption lines.The Mossbauer results froma range of compositions revealed the roomtemperature phase behaviour of the ferrite also examined using x-ray diffraction. ¶ The high-temperature crystal structure of the ferrite was examined using neutron powder diffraction.The measurements were done at temperatures up to 1273K in argon and air atmospheres.The former atmosphere protects Sr2Fe2O5 (x=2.5) against oxidation and the measurements in air allowed variation of the composition of the oxide in the range 2.56 ≤ x ≤ 2.81. Sr2Fe2O5 is an antiferromagnet and undergoes phase transitions to the paramagnetic state at 692K and from the orthorhombic to the cubic structure around 1140K.The oxidized formof the ferrite also undergoes a transition to the high-temperature cubic form.The author proposes a new structural model for the cubic phase based on a unit cell with the Fm3c symmetry. The new model allows a description of the high-temperature cubic form of the ferrite as a solid solution of the composition end members.The results were used to draw a phase diagramfor the SrFeOx system. ¶ The last chapter summarizes the findings and suggests directions for further research.

Non-stoichiometric strontium iron oxide is described by an abbreviated formula SrFeOx (2.5 ≤ x ≤ 3.0) exhibits a variety of interesting physical and chemical properties over a broad range of temperatures and in different gaseous environments. The oxide contains a mixture of iron in the trivalent and the rare tetravalent state. The material at elevated temperature is a mixed oxygen conductor and it, or its derivatives,can have practical applications in oxygen conducting devices such as pressure driven oxygen generators, partial oxidation reactors in electrodes for solid oxide fuel cells (SOFC). ¶ This thesis examines the behaviour of the material at ambient and elevated temperatures using a broad spectrum of solid state experimental techniques such as: x-ray and neutron powder diffraction,thermogravimetric and calorimetric methods,scanning electron microscopy and Mossbauer spectroscopy. Changes in the oxide were induced using conventional thermal treatment in various atmospheres as well as mechanical energy (ball milling). ¶ ...