Academic literature on the topic 'Needle-to-stem unit ratio'

The study objective was to compare intraspecific seed source and interspecifc variation of red spruce (Picea rubens Sarg.) and black spruce (Picea mariana (Mill.) BSP) in a number of morphometric, allometric, and adaptive traits. Analyses of variance for cotyledon number, root dry weight, shoot to root ratio, and seedling water balance revealed significant species effects. Germination time, total height, diameter, needle and stem wood dry weight, and survival had significant species effects and species × region interactions. Potential inbreeding depression effects were reflected in a positive relationship between height growth and percent germination and a negative relationship between height growth and germination time; these effects may have partly contributed to the species × region interactions. On average, 66% of the height growth difference between the species may be attributable to earlier germination and the other 34% to faster growth. Covariate allometric analysis showed that black spruce had a 39% higher shoot to root ratio than red spruce. Red spruce allocated 25% more dry weight (per unit needle weight) towards roots than did black spruce. When the resource sinks (stem wood and roots) are summed, black spruce is 8.6% more efficient at converting resources into sink biomass than is red spruce.

This paper reports on foliage and tree size data collected in 1984 in an Ontario Pinusbanksiana Lamb, (jack pine) provenance trial established in 1954 at the Petawawa National Forestry Institute, Chalk River, Ont. The ratio of total needle area to needle dry weight of seven provenances showed a substantial within-tree, between-tree, and between-provenance variation that was associated with position within the tree and the average provenance tree size. Provenance mean values ranged from 11.7 to 14.3 m2/kg. The highest values were found in the tallest trees. Tree size and dry matter content varied significantly among provenances, but the relative growth rates of stem volume and aboveground biomass between the ages of 29 and 34 years averaged 5.7 and 4.9% per year in all provenances respectively. Aboveground dry matter production per hectare per year increased linearly with increasing projected leaf area index. The average increase was 1.9 t dry matter per l m2 increase in the leaf area index. Projected leaf area indices for optimally stocked stands averaged 5.0 m2/m2. The results indicated an almost constant net assimilation rate of 1.9 g aboveground dry matter per square decimetre of projected foliage per year in all provenances. Canopy foliage area was strongly correlated with basal area at 1.3 m and stem cross-sectional area at the base of the live crown. Total foliage area per unit basal area averaged 0.31 m2/cm2 at breast height and 0.70 m2/cm2 in the live crown. No significant differences were found between provenances.

Ectomycorrhizal seedlings of Scots pine (Pinussylvestris L.) were subjected to repeated artificial defoliation (0, 25, 50, and 75%) to demonstrate the effect of a reduced amount of photosynthates on the allocation of biomass between the tree and its fungal symbionts. Defoliation reduced shoot biomass in the seedlings significantly, and belowground parts adjusted to the same growth level. Biomass parameters of seedlings that had undergone the mildest defoliation treatment did not differ significantly from control seedlings, while the two most intensive treatments reduced growth and biomass of seedlings in a similar way. Defoliation did not reduce mycorrhizal colonization or fungal biomass calculated per unit weight of fine roots. Actual needle biomass in seedlings correlated positively with stem biomass, total root biomass, fungal biomass both in roots and in soil, and the number of mycorrhizal root tips per seedling. Root/shoot ratio and total allocation pattern were relatively constant.

Needle-to-stem unit rate (NESTUR) is a stem growth index of conifer seedling trees that measures the efficiency of stemwood production per unit of needle growth. Five experiments were carried out in this thesis using progenies of two unrelated full-sib radiata pine crosses. The initial experiment (experiment 1) applied the bulked segregant analysis technique to determine whether RAPD analysis could be successfully extended to the development of molecular markers for NESTUR in radiata pine. The NESTUR values of 174 progenies of the full-sib family 12038 x 10946 were determined. Based on the genotypic analysis of the individuals, two quantitative trait loci (QTL) controlling NESTUR were identified at ANOVA P-levels of 0.01-0.001. An absence of RAPD fragment markers generated by primers OPE-06 and OPA-10 was associated with low NESTUR values, while primer UBC-333 generated a 550 bp band that was associated with high NESTUR values. Linkage to components of NESTUR (increments in stem diameter and stem volume) was demonstrated for one of the QTL, while the other was unique to NESTUR, and not shared with the components. There was a significant interaction between the two QTLs. Presence of OPA-101200 locus appeared to inhibit expression of the QTL linked to UBC-333 [subscript 550]. ¶ To further analyse the quantitative trait loci (QTLs) controlling NESTUR, a linkage map was constructed from RAPD markers segregating in 93 haploid progeny of another full sib cross (30040 x 80121) (experiment 2). Two hundred and sixty-two (262) markers were mapped to 14 linkage groups of at least 7 markers, ranging in size from 39 to 183 cM. The 14 linkage groups covered approximately 1511 cM of genetic map distance. ¶ In experiment 3, the linkage map was used to map QTLs controlling NESTUR, as well as increments in seedling stem diameter, volume, and height and needle volume. Altogether, five putative QTLs were detected for NESTUR, with explained variation ranging from 9 to 22%. Of the five QTLs detected, 3 were coincidental with those for stem growth in height, diameter and volume. The two QTL positions that were unique to NESTUR were flanked by QTLs for the component traits. Together, effects of the five QTLs explained 48% of the total phenotypic variation for NESTUR. ¶ Ability of identified markers to predict the phenotype and seedlings with growth potential was assessed in the cross 30040 x 80121, using six RAPD markers associated with NESTUR at ANOVA P-levels of 0.01-0.001 (experiment 4). The correlation between observed NESTUR and predicted values was 0.70. Differences in observed vs. predicted values were not large and did not indicate serious misclassifications, such as classification of an upper ranking individual into the lower group, or vice versa. ¶ Over a two-year growth period, the ability of NESTUR to predict stem growth was strongly affected by seedling age. In contrast, markers linked to NESTUR showed a consistent ability to predict stem growth, irrespective of seedling age. Compared with the top 1% of the original population, seedlings selected for their genotypic values showed a higher stem volume growth of 103% in the first year, and 76% in the second year. ¶ The expression of QTLs for stem volume, stem diameter, height, number of branches, number of whorls, and branches/whorl were compared at 5, 12, and 24 months of age. Two QTLs detected for height showed contrasting expression over two years, one was gradually reduced from LOD of 2.70 to 0.43 and the other increased from 1.12 to 2.45. Compared with the pattern observed for height, LOD scan profiles for diameter and volume showed less temporal change of peaks, suggesting that the genetic control for height growth is probably more unstable than that of diameter. QTLs controlling the phenotype at the time of measurement (ie the final phenotype) showed similar magnitude of effects on that trait's respective increments (or growth rate).

Needle-to-stem unit rate (NESTUR) is a stem growth index of conifer seedling trees that measures the efficiency of stemwood production per unit of needle growth. Five experiments were carried out in this thesis using progenies of two unrelated full-sib radiata pine crosses. The initial experiment (experiment 1) applied the bulked segregant analysis technique to determine whether RAPD analysis could be successfully extended to the development of molecular markers for NESTUR in radiata pine. The NESTUR values of 174 progenies of the full-sib family 12038 x 10946 were determined. Based on the genotypic analysis of the individuals, two quantitative trait loci (QTL) controlling NESTUR were identified at ANOVA P-levels of 0.01-0.001. An absence of RAPD fragment markers generated by primers OPE-06 and OPA-10 was associated with low NESTUR values, while primer UBC-333 generated a 550 bp band that was associated with high NESTUR values. Linkage to components of NESTUR (increments in stem diameter and stem volume) was demonstrated for one of the QTL, while the other was unique to NESTUR, and not shared with the components. There was a significant interaction between the two QTLs. Presence of OPA-101200 locus appeared to inhibit expression of the QTL linked to UBC-333 [subscript 550]. ¶ ...