Academic literature on the topic 'Inline sorting'

Manipulation and sorting of particles utilizing microfluidic phenomena have been a hot spot in recent years. Here, we present numerical investigations on particle trapping techniques by using intrinsic hydrodynamic effects in an expansion-contraction microfluidic device. One emphasis is on the underlying fluid dynamical mechanisms causing cross-streamlines migration of the particles in shear and vortical flows. The results show us that the expansion-contraction geometric structure is beneficial to particle trapping according to its size. Particle Reynolds number and aspect ratio of the channel will influence the trapping efficiency greatly because the force balance between inertial lift and vortex drag forces is the intrinsic reason. Especially, obvious inline particles contribution presented when the particle Reynolds number being unit. In addition, we selected three particle sizes (2, 7, and 15 μm) to examine the trapping efficiency.

HighlightsIn the Emission Head (EH) configuration differences in apple bruise severity were well captured.A good representation of new samples variability, in calibration, ensured robust quantitative PLS-DA models.EH mode with PLS-DA is an attractive spectroscopic option for inline apple sorting based on bruise damage. Abstract. Bruise damage in apples is very common and undesirable because it hinders consumer satisfaction and greatly contributes to food loss. Fast detection of bruise damage in fruit using spectroscopic systems is still problematic, especially in terms of quantitative and objective assessments of mechanical damage and standardization of bruise measurement method, among other issues. Non-destructive techniques among which is near infrared (NIR) spectroscopy are under development as a potential solution carrier for such issues. A study of bruise damage was conducted on three apple cultivars using Fourier transform (FT) near infrared spectroscopy in two configurations (‘emission head’ of Bruker’s Matrix-F and ‘integrating sphere’ of Bruker’s multipurpose analyzer, MPA). The emission head (EH) allows for contactless large sample (100 mm) exposure that simulates on-line applications, while the MPA (sample size: 22 mm) is commonly used for in-laboratory analysis of inhomogeneous material such as fruit. Bruise damages were mechanically induced in apples, bruise sizes measured physically and destructively. Partial least squares discriminant analysis (PLS-DA) was used to determine the differences captured by the scanning spectrometers in apple fruit tissues. Discriminant analysis revealed that in both sample acquisition modes, distinction between bruised and non-bruised apple fruit tissue was achieved with high (from 78% to 93%) accuracy of classification (ACcl) based solely on spectral data. The classification accuracy improved when individual cultivars were considered and ranged from 94% to 96%. Classification models were tested for robustness and showed that both cultivar and bruise severity had influence on classification models’ performance. The results showed ability of the emission head configuration in detecting bruises and differentiating between severity of bruises in apple fruit, thus making it a good candidate for use in rapid detection and quantitative assessment of bruising in apple on sorting lines. Possibilities for improving the classification model performance and ensuring their robustness for the EH were suggested. Keywords: Apple bruise, Discriminant analysis, Model performance, Model threshold, NIR spectroscopy.

ABSTRACTDome dunes in four stabilized, inland dune fields in western Canada are predominantly composed of horizontal to low-angle cross-strata, indicating that slip face development was rare. Dip angles of lee side deposits decrease upward in the dome dunes. The spread of dip directions increases with elevation in the dunes, spanning 360° for topset deposits. Sedimentary structures indicative of moisture (adhesion laminae) and vegetation (scour surfaces) occur in the dunes and denivation features are also present. Sediment adhesion is responsible for the maintenance of the dome morphology. Sediment sorting within the dome dunes is poorer than in other local dune types in the vicinity, suggesting that less reworking/ineffective selective transport occurred and that the dome dunes are more efficient in retaining sediment. The rarity of slip face and grainfall deposits and the abundance of low angle deposits indicate that preferential accumulation of sediment at the top of the lee side did not occur. Development of domal morphology is a consequence of the inhibition of slip face development. In inland, relatively moist boreal environments, the primary factor limiting or precluding sediment accumulation at the crest of the dunes is a low rate of sedimentation.

AbstractLate Holocene sediment deposits in Pine Island Bay, West Antarctica, are hypothesized to be linked to intensive meltwater drainage during the retreat of the paleo-Pine Island Ice Stream after the Last Glacial Maximum. The uppermost sediment units show an abrupt transition from ice-proximal debris to a draped silt during the late Holocene, which is interpreted to coincide with rapid deglaciation. The small scale and fine sorting of the upper unit could be attributed to origins in subglacial meltwater; however the thickness and deposition rate for this unit imply punctuated- rather than continuous-deposition. This, combined with the deposit's location seaward of large, bedrock basins, has led to the interpretation of this unit as the result of subglacial lake outbursts in these basins. However, the fine-scale sorting of the silt unit is problematic for this energetic interpretation, which should mobilize and deposit a wider range of sediment sizes. To resolve this discrepancy, we present an alternative mechanism in which the silt was sorted by a distributed subglacial water system, stored in bedrock basins far inland of the grounding line, and subsequently eroded at higher flow speeds during retreat. We demonstrate that this mechanism is physically plausible given the subglacial conditions during the late Holocene. We hypothesize that similar silt units observed elsewhere in Antarctica downstream of bedrock basins could be the result of the same mechanism.

Bukit Keluang is one of the famous natural recreational sites in Besut, Terengganu due to their beautiful sandy beaches and beautiful landscapes. Bukit Keluang recreational forest consist coastal and lowland dipterocarp forest. The studies on the biodiversity are never been reported at this area and thus, we aimed to investigate the diversity and abundance of insects in the coastal and inland forest of Bukit Keluang recreational forest. We built two plots which are Plot A in the coastal area and Plot B in the inland forest at Bukit Keluang. For each plot, three types of insect traps were used; yellow pan traps, pitfall traps, and Malaise traps. The traps were left for seven days and all insect samples collected were brought to the laboratory for sorting, enumerating and identifying up to order level. A total of 455 individuals of insects consisted of 10 orders (i.e. Hymenoptera, Diptera, Lepidoptera, Coleoptera, Collembola, Homoptera, Orthoptera, Dermaptera, Blattodea and Isoptera) were successfully collected from the forest of Bukit Keluang. Among them, Hymenoptera order dominated the number of individuals collected at 67.25% followed by Diptera (11.21%) whilst Collembola and Dermaptera were the least abundance order collected at 0.22%, respectively. The coastal forest recorded a total of 271 individuals (nine orders) while inland forest recorded 184 individuals (eight orders). No significant difference (p>0.05) of insect abundance was recorded between both plots. However, the Shannon-Weiner Diversity Index (H’) showed that the diversity of insects in the inland forest was slightly higher (H’=1.52) than the coastal forest (H’=0.86). We conclude that the insects’ diversity in Bukit Keluang is relatively higher in inland forest but lower in coastal forest. As no other insect survey has been conducted in this study area in the past, this study delivers a basic evidence and dataset of diversity and abundance for insect which may beneficial for further conservation research at Bukit Keluang in the future.

AbstractThe North Pacific Ocean (NPO) has received abundant aeolian dust transported by westerlies from the Asian inland. The aeolian components preserved in NPO sediments record information on palaeoclimatic and palaeoenvironmental changes in Asian source areas at different timescales. Previous studies have systematically investigated the source–sink effect of aeolian dust using the sedimentology, geochemistry, isotope and magnetic methods. In this study, we focus more on recent developments of aeolian signals in NPO sediments obtained by magnetic approaches. Generally, aeolian components contain a mixture of magnetite, maghemite, hematite and goethite of different origins. Magnetic properties (mineral category, concentration and particle size) of these minerals are modulated primarily by climatic/environmental conditions in source areas and sorting effects during the transportation process. Compared with the other methods, magnetic measurements have the advantages of non-sample destruction, high sensitivity and high efficiency. Finally, future studies are also discussed to address the importance of magnetism for tracing the dynamic transportation processes of the aeolian dust.

ABSTRACT In October 2012, Hurricane Sandy caused severe erosion on beaches and dunes of Fire Island (New York, USA). Major shoreline changes occurred with erosional dominance in the upper shoreline and aggradation in the lowermost section of the beach due to the deposition of eroded upper-beach and dune sediment. Sand laminae with a high concentration of heavy minerals (“black sand laminae”) were observed in three excavated trenches located on a washover terrace and fan on the east side of Fire Island. The mineral composition of these laminae reveals the presence of high quantities of magnetite, ilmenite (as opaque minerals), and garnet (as the main translucent mineral). These heavy-mineral-enriched laminae were formed as waves eroded and transported sand from the primary dune and smaller relict dunes under specific hydrodynamic conditions that promoted grain sorting according to differences in size and specific gravity. Based on the concentrations of certain heavy minerals, the threshold for primarily density-driven sorting probably lies between the specific gravity of less dense opaque mineral (ilmenite, 4.7) and almandine (4.3), the most common transparent heavy mineral. The number of laminae and concentrations of heavy minerals vary between trenches on the overwash terrace and appear to be controlled by their distance from sediment sources. The trench with the greatest number of laminae and higher heavy-mineral concentrations is located farthest from the main dune but is just 10 m inland of a relict dune that acts as the primary source of sediment of the washover deposit in this trench. A conceptual model for deposition of heavy-mineral layers is presented based on geomorphological and sedimentological evidence allowing the definition of a density threshold.

Total soluble solids (TSS) is a reliable indicator of melon eating quality, with a minimum standard of 10% recommended. The state of Australian melon production with respect to this quality criterion was considered within seasons, between growing districts and over seasons. It was concluded that improvement in agronomic practice and varietal selection is required to produce sweeter melons. The scientific literature addressing melon physiology and agronomy was summarised, as a background to the work that is required to improve melon production practices in Australia. The effect of source sink manipulation was assessed for commercially grown and glasshouse grown melon plants. The timing of fruit thinning, pollination scheduling, the application of a growth inhibitor and source biomass removal were assessed in relation to fruit growth and sugar accumulation. Results are interpreted against a model in which fruit rapidly increase in weight until about two weeks before harvest, with sugar accumulation continuing as fruit growth ceases. Thus treatment response is very dependant on timing of application. For example, fruit thinning at 25 days before harvest resulted in further fruit set and increased fruit weight but did not impact on fruit TSS (at 9.8%, control 9.3%), while thinning at 5 days before harvest resulted in a significant (Pless than 0.05) increase in fruit TSS (to 10.8%, control 9.3%) and no increase in fruit weight or number. A cost/ benefit analysis is presented, allowing an estimation of the increase in sale price required to sustain the implementation of fruit thinning. The effect of irrigation scheduling was also considered with respect to increasing melon yield and quality. To date, recommended practice has been to cause an irrigation deficit close to fruit harvest, with the intent of 'drying out' or 'stressing' the plant, to 'bring on' maturity and increase sugar accumulation. Irrigation trials showed that keeping plants stress-free close to harvest and during harvest, facilitated the production of sweeter fruit. The maintenance of a TSS grade standard using either batch based (destructive) sampling or (non-invasive) grading of individual fruit is discussed. On-line grading of individual fruit is possible using near infrared spectroscopy (NIR), but the applicability of the technique to melons has received little published attention. Tissue sampling strategy was optimised, in relation to the optical geometry used (in commercial operation in Australia), both in terms of the diameter and depth of sampled tissue. NIR calibration model performance was superior when based on the TSS of outer, rather than inner mesocarp tissue. However the linear relationship between outer and middle tissue TSS was strong (r2 = 0.8) in immature fruit, though less related in maturing fruit (r2 = 0.5). The effect of fruit storage (maturation/senescence) on calibration model performance was assessed. There was a negligible effect of fruit cold storage on calibration performance. Currently, the agronomist lacks a cost-effective tool to rapidly assess fruit TSS in the field. Design parameters for such a tool were established, and several optical front ends compared for rapid, though invasive, analysis. Further, for visualisation of the spatial distribution of tissue TSS within a melon fruit, a two-dimensional, or hyper-spectral NIR imaging system based on a low cost 8-bit charge coupled device (CCD) camera and filter arrangement, was designed and characterised.